conteHome > Mini Cooper > Mini Cooper Driving Lights Not Working

Mini Cooper Driving Lights Not Working

Contents

Very useful It will no doubt be a great help, though The 9 hour installation would put me off before even starting! Details? Large Image | Extra-Large Image Figure 35 Shown here is the stock cable loom removed from the hinge. At the bottom of the PDF I mentioned, there's a section for "vehicles with sports package", with instructions for four-fin and three-fin grills. have a peek here

Loading... Pull the wiring loom up all the way through (See Figure 57 and Figure 58).Now take one of the ring terminals supplied with the kit and crimp in on to the They are held in place by blocks of foam at the bottom. As such it has no official relationship with MINI USA, BMW AG, or BMW of North America.All original artwork and design is Copyright 2002-2004 North American Motoring. http://www.northamericanmotoring.com/forums/electrical/262652-rally-lights-not-working.html

How To Turn On Mini Cooper Rally Lights

This is the instrument backlight power lead and will illuminate the control switch for the driving lights when you turn the headlights on (See Figures 23, 24 and 25).Now move over Loading... Large Image | Extra-Large Image Figure 13 Remove the two lower screws attaching the bezel to the dashboard. (green arrow) This picture shows the passenger side. I am not sure.

halfords? This will allow you to remove the two pillar covers on the center console. Cut the cable ties off the stock loom (See Figures 33, 34 and 35). Mini Cooper Fog Lights Installation TechFlow 104,646 views 11:37 Talking Cars with Consumer Reports #33: Mini Cooper | Consumer Reports - Duration: 17:03.

Then drill a small hole for the wires to run through the back of it and then cut out one of the existing blank buttons. It is hinged at the bottom, so rotate it down and carefully remove the panel. HorgisDrivingSchool 15,561 views 2:32 Show me, tell me questions 2016: Practical driving test questions. - Duration: 9:25. It is hinged at the bottom, so rotate it down and carefully remove the panel.

On the back of the driving light bulb, you'll see a small Phillips head screw. How To Turn On Mini Cooper Headlights The idea is to have the mounting surfaces of the bracket sit flush against the hood. This will act as the ground point for the wiring. Tie the wire to the ground lug and pull it back out of the grommet.

Mini Cooper R56 Spotlights

Tires Find the right tires for your car Insurance Get a free insurance quote -- Mini F56 Forum (Full) -- Mini F56 Forum (Mobile) Contact Us | Advertise | 2015

Mini cooper driving lights won't work \015 Dash switch has power\015 Answers : Repair Help & Product Troubleshooting for Cars & Trucks Please enable JavaScript to view the comments powered by How To Turn On Mini Cooper Rally Lights Large Image | Extra-Large Image Figure 63 Inside the car, secure the relay socket to the wiring harness and plug in the relay supplied with the kit. Mini Cooper Fog Light Switch Join us in our MINI Cooper Technical Forum Message Board and ask a question to one of our many automotive experts.

They can help you find the right part. - Nick at Pelican Parts Liam Comments: I found one other installation guide besides this one; it's a PDF; looks kind of navigate here Language: English (UK) Content location: United Kingdom Restricted Mode: Off History Help Loading... Performance Gain: better lighting Complementary Modification: replace front grille This article is one in a series that have been released in conjunction with Pelican Parts' new book, How to Maintain and Also, be sure to cut the small index mark in the hole for the switch (See Figure 49).Re-fit the bolster panel up underneath the dashboard and press the switch into the Mini Cooper Fog Lights Not Working

The time now is 08:15 AM. Loading... Large Image | Extra-Large Image Figure 3 Remove the screws holding the console pillar to the driver's side. Check This Out You can see in the kit pic below where the connection wires come out of the housing.

Large Image | Extra-Large Image Figure 26 Now move over to the passenger side of the car and pull the trim panel off the inside of the car near the hood Mini Cooper Fog Lights Kit Thanks for your help February 7, 2015 Followup from the Pelican Staff: If the fuse missing power when the lights are turned ON? - Nick at Pelican Parts cheekal Password Register Forgot Password?

Large Image | Extra-Large Image Figure 28 Now route the yellow/green wire behind the dashboard and over to the passenger side (green arrow).

September 25, 2013 Followup from the Pelican Staff: There is a metal spring clip, shown here on the right side of the photo. Sign in to add this video to a playlist. Extras •Tech Forums •Parts Catalog Mini Home> MINI Cooper Technical Articles> Driving Light Installation Pelican Technical Article: Driving Light Installation Wayne R. Mini Cooper Fog Light Bulb Replacement Large Image | Extra-Large Image Figure 10 After you lower the glovebox down, disconnect the electrical harness going to the glovebox light by pulling it out of the light assembly.

Large Image | Extra-Large Image Figure 29 Use a pick or screw driver to pull the locking tab on the bottom of the harness connector towards you. Next, remove the glovebox assembly and set it aside (See Figures 9, 10 and 11).Now look along the lower edge of the instrument bezel panel. I looked for a fuse and couldn't find on maybe in-line fuse in wiring harness perhaps??? __________________ Sid: 09 MCS PW|Megan Racing Coilovers|AEM Intake|Invidia Catback|Alta AP|NM 22mm Sways|Red Mirrors|JCW Front Bumper this contact form Edlin 16,131 views 3:40 How-To Wire Offroad Lights - Duration: 9:16.

Also, make sure you you test your lamp (bulb), easy way with a multi-meter and check for continuity. Large Image | Extra-Large Image Figure 52 Now move to under the hood and mock up the light brackets in place and use a permanent marker to mark the position of Take the supplied wire connector and route the new wiring loom so that the two wires sit in the connector as shown. Mod MINI 32,549 views 5:20 Fog light driving lessons - Duration: 1:50.

Pull up the carpeting and the foam liner underneath to expose the body control module or (BCM). Use a Dremel or a razor knife to cut through the plastic. Today 12:09 AM by Knodel 9 Keeping the Run Flats -... YoungDriversofCanada 13,616 views 1:50 girl Driving a Ferrari - Duration: 9:55.

Nissan Owner Channel 12,631 views 2:12 How to deal with roundabouts driving lesson: Easy to understand UK roundabouts - Duration: 20:52. Loading... light relay, the aux. and does not seem to function at all?

This will release the connector from the radio (See Figure 19).Now look at the front firewall near the brake booster. Loading... Dying to learn about where the switch is ... If yours work like that, then they are working fine.

It's a good idea to slide some heat shrink tubing onto the line as well to insulate the connection. Take your time and be careful. Share Share this post on Digg Del.icio.us Technorati Twitter The Nun is offline Quote Quick Reply post #7 of 7 (permalink) Old Aug 17th, 2012, 12:40 PM Thread Starter mattmyself Watch Queue Queue __count__/__total__ Headlights, High Beam and Fog Light controls in a Mini Cooper - Driving Lessons Driving Magic SubscribeSubscribedUnsubscribe3,4003K Loading...

nt