conteHome > Not Working > Microwave Sensor Not Working

Microwave Sensor Not Working

Contents

I have just forwarded this onto a coworker who has been doing a little research on this. Working... I wish someone would have answered your question. This document provides maintenance and repair information applicable to most of the microwave ovens in existence. Source

The magnetron can be tested by setting an ohmmeter to its highest resistance scale. You could discover your old microwave very soon heads to a great property. You deserve for much more traffic. Enter your model number for the best repair help results: What is a model number, and where do I find it?

My Microwave Won't Turn On

Use an isolation transformer if there is any chance of contacting line connected circuits. If you have basic confident working with electronic, replacing this part is not difficult. Great arguments. While doing it we noticed the black wire that comes thru the door was cut.

misterfixit 47,853 views 8:10 Microwave Door Switch Test MIcrowave Repair Help - Duration: 2:19. In addition, the wavelength (about 5 inches) results in reasonable penetration of the microwave energy into the food. She said the microwave was hot and there was a soder like smell. Microwave Door Sensor Switch Reply Michael says: June 13, 2015 at 2:24 am Have a GE JVM1950 over the range microwave that comes on every time the door is opened even though it was not

How do I change the power level on my microwave? Microwave Won't Start Add to Want to watch this again later? When I shook it getting the access panel off, it lit up again and worked perfectly again. http://www.partselect.com/Microwave+Repair+repair.htm i have not been able to get a better answer than 'a wire mesh'.

The fuse didn't blow. Microwave Turns On But Does Not Heat Select a convenient location - easy access and not too high or too low. Regards, - Ivan If everything is unbroken, gently clean the terminal end of the flex circuit with a pencil eraser, reassemble, and try again. Connect/disconnect any test leads with the equipment unpowered and unplugged.

Microwave Won't Start

It will shut off periodically for a few minutes but then turns back on. I ended up replacing the line fuse, reseating the ribbon cable into the control panel, and adjusting a loose wire on one of the thermal fuses. My Microwave Won't Turn On The cover will then lift up and off. Microwave Not Turning On The problem: Before today we had no problems, I used the microwave for a 49 second pizza warm up, threw 2 more slices in for another 40 and at 32 seconds

Place the red lead into the red wire and black lead into the white wire. 4. http://3rdm.org/not-working/microwave-touch-buttons-not-working.php Choose your language. This really stinks. However, there have been some back in the 1970s that did this with a 1 second or so pulse width modulated cycle, fast enough to have the same effect as continuous Microwave Stopped Working No Power

But when the cover is replaced with the screws in random locations, there's a high probability that the oven no longer works at all. Reply ge small microwave says: December 11, 2014 at 6:51 pm They also bring 1-year warranties on parts as well as labor, and also an exclusive 10-year guarantee on its magnetron It's probably 10-15 years old, has a single board behind the keypad. http://3rdm.org/not-working/microwave-touchpad-not-working.php Schedule Service Online Update a Service Appointment or Check Pricing GE Appliance Service 1-800-GECares (1-800-432-2737) Monday–Friday: 7 a.m.–10 p.m.

Was this answer helpful? Ge Microwave Troubleshooting No Power The paint inside my microwave is chipped or scorched. Most amateurs and even many professionals do not own an RF leakage meter.

Reply HULDickalgh says: September 21, 2015 at 9:58 pm It was hard to find this article in google, but i am glad i found your awsome site.

You will wonder how you ever lived without one! While I watch the light flash - As soon as I try to set anything - then the flashing ‘0' goes out. CAUTION: Your microwave oven is capable of giving you a serious electrical shock, even when it is unplugged. Microwave Timer Not Working I guess that it could also be bad solder where the flex connector is soldered to the u-processor board, but this would be uncommon.

It consists of two parts: the controller and the microwave generator. Such an open mesh should not affect the cooling of the electronic components significantly. Check that the plug (or adapter) fits tightly and that there is no appreciable heating of the outlet during use of the microwave oven. Check This Out Thanks!

If your discharging did not work, you may blow everything - including yourself. If circuit boards need to be removed from their mountings, put insulating material between the boards and anything they may short to. neptunewaxmotorcom 12,248 views 8:31 How to test the Microwave Oven's HV Diode - Duration: 10:13. For references, check books on microwave spectroscopy by Townes and Gordy." Since the oven chamber cavity is a good reflector of microwaves, nearly all the energy generated by the oven is

Recall Alerts Careers PartSelect Canada Free Repair Help Appliance Repair Instant Repairman Dishwasher Dryer Microwave Range / Stove / Oven Refrigerator Washing Machine Helpful Resources PartSelect Community Twitter Facebook Page YouTube Thanks for the meal!! If I jiggle this bundle of wires, in any direction, I hear a clicking noise like the light toggle on an old fridge, and power either goes out completely or is Daniel Hawk 202,689 views 16:13 Repair Replace bad Door Switch Mechanisms on a Whirlpool Microwave - Duration: 3:44.

Then, touch one of the meter's probes to a magnetron terminal and the other one to the metal magnetron housing.

nt